Cleared bed, though accidentally started a new project on top…
After of junk table, just a bit left now
Before of junk table
3
After removing unused stuff, finishing off tasks I physically put into my queue.
Before of organising desk
Swooped out the microcontroller on my keyboard since the micro USB port ripped out. Hopefully this USB-C port is more sturdy. Old one sitting on top. Used a new socket method which was a lot cheaper and less exotic than what I used before.
Testing out negative conversion software. This one saves a lot of the manual steps. I may need to re-scan this roll though, there's a lot of dust.
2
Finished up a couple rolls of 135, now going to 120
Cleaned up corner next to desk. Needs some wiring adjustments but much better now.
organised the remjet from non-remjet so I don’t ruin anyone’s chemicals